Enable Energy Saver Globally
About this task
Perform this procedure to enable Energy Saver globally on the switch. You can optionally configure PoE power savings, to power off low priority PoE devices during off-peak times.
Before you begin
-
You must enable Energy Saver on individual ports.
-
You must create an Energy Saver schedule.
Procedure
Example
Switch:1>enable Switch:1#configure terminal
Switch:1(config)#energy-saver poe-power-saving
Switch:1(config)#energy-saver enable
Variable Definitions
The following table defines parameters for the energy-saver command.
Variable |
Value |
---|---|
enable |
Enables Energy Saver feature. The default is disabled. |
poe-power-saving |
Enables PoE power saving. The default is disabled. |